PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home

JVC service or questions

Stacy Sample Posted Jan 31, 2004

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better. Stacy Sample JVC Service & Engineering Houston, Texas

Reply

Share |
6,445 comments, pages:   « 1 2 3 564 565 566 567 568 569 570 643 644 645 »

    The VCR won't power on or off. There's a tape inside. The only thing I can do is change the channels. Is there a simple solution to my problem?

    Reply

    I have model GR-D30U and experienced the condensation warning in the past, but it would go away. It is not the middle of December and extremely dry in the house..no possible way for condensation. The camera has been on for 24 hours and the condensation warning will not go away, rendering the camera inoperable. Can you help? This seems to be a commen problem...I did a quick search and found several others who are experiencing the same. Thanks.

    Reply

    I have a JVC GR D30u, suddelny a warning message "operation stopped, condensation problems appeared. I havent be able to use my camera since then. I doesn matter what I do with the camera (air conditiones for a whole night, winter time etc. It is permanent.

    Comment 1, Last comment by Jon Amundson Dec 19, 2004

    hi Stacy, my JVC svcd component,mx-j680v could not detect disc,"no disc" as its message indication. I clean it with disc cleaner, nothing happen. could i check it using my fluke multi-meter/tester? how? thanks emmanuel

    Reply

    Re: JVC service or questions

     Michael Posted Dec 09, 2004

    I have a JVC DR-M10S that worked perfectly for about three months and now crashes a lot, esp when recording to DVD-R (same type as have used many times before without a problem and even from same spindle). I end up with it just falsing LOADING over and over. I read that there was a firmware update to fix the issue but can find no such thing

    Comment 1, Last comment by Srgio Salvado Dec 19, 2004

    hi. i have trouble recording on my jvc digital camera gr-dvm90u video cam.i get the message "E04 unit in safeguard mode. remove and reattach battery." it happens at the worst times like when i'm about to film my kids' performances , etc. please help! i just replaced the old battery with a larger capacity one but it still does this. thank you!

    Reply

    i keep getting the same error message e01 reattach battery unit in safeguard mode and will not go away any help will be appreaciated

    Reply

    i have JVC mini dv digital video camera.I used a different power supply cord to charge the battery,while battery is on camera.The cord i used talked about getting the polarity correct.When i connected to power it blinked a few times so i unplugged it.Finally, i found the correct cord for my camera but it doesn't work.I even tried a new battery. Did i fry my video camera? can it be fixed? help!! jvc digital video,model no.gr-d30u

    Reply

    I need operation manual for the audio equipment JVC DR-E59. Also, if this is possible, I need the electrical squematic manual. This equipment have one speaker system of 3 way bass reflex type SP-E58 for power handling capacity 50 watta, 8 ohms.

    Reply

    I had the same problem that numerous people on this forum have complained about with my JVC-36-980. Would not power up. I followed the advice that was suggested in the forum to swap out the 1000uF 35V capacitor. Set now works great. It is a very simple fix and is worth trying before calling a service repair man. I am far from an electronics wiz and I had no problem replacing this capacitor on the circuit board The capacitor is located at C926. I am not saying that this will fix all power up problems but there appears to be a problem that is occuring with the xx980 series after about a 5 year period with this capacitor. JVC should have a recall on this and fix the part. I wonder how much money has been charged by repairmen over the years to make this simple fix ? I think I have bought my last JVC. Thanks to the internet I have saved a couple hundred dollars.

    Reply

Pages:   « 1 2 3 564 565 566 567 568 569 570 643 644 645 »



  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed