PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home

JVC service or questions

Stacy Sample Posted Jan 31, 2004

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better. Stacy Sample JVC Service & Engineering Houston, Texas

Reply

Share |
6,445 comments, pages:   « 1 2 3 28 29 30 31 32 33 34 643 644 645 »

    Re: JVC service or questions

     kourosh Posted Dec 25, 2009

    hi, my camcorder dosent turn on and make some repeated noise when i put battery in that or even with DS power (plugin) so I am sure that battry is Ok but there is problem with software, I tried to reset it but still it dosent show any light or flashing , etc. only make some noise inside the camcorder. , ( JVC 30 GB HDD Everio) thanks

    Reply

    Re: JVC service or questions

     jeremy Posted Dec 25, 2009

    I have a jvc home stereo and I need to know how to fix cd-dvd mechanism? the model # is ca-hdx7. thank you.

    Reply

    I have a JVC camcorder model GZ-MG30U and it will not charge when i plug it in. The light starts to flash and then it just goes out. Should i get a new battery or a new charger cord? Not sure what the problem is. Thanks.

    Reply

    Hi, first of all MERRY CHRISTMAS!!! I have a JVC HX-D7, at on no sound, after 15 to 30 seconds goes to protect, please need help to fix this problem. Thanks Orfelino Perdomo Miami,Fl

    Reply

    Re: JVC service or questions

     JC Posted Apr 16, 2009

    Problem with JVC MX-GC5 Every time i try to turn it on "PROTECT" error message pops up. then it turns itself off. Any Help? saw your post on PECHORIN'S

    Comment 1, Last comment by guy Dec 22, 2009

    I have a large JVC tv. Since two days ago, the top half of my screen goes black and the bottom half shows the top half of the picture.

    Reply

    Hi i have a jvc gydv500 and my camera had crashed from my table. Now, the tape isn't ejecting. Please can you tell me what is the problem? jonathan

    Reply

    Re: JVC service or questions

     Joann Posted Dec 18, 2009

    I have a JVC model #AV-20120 Tv and my red on timer light is blinking and I cant get the tv to turn on at all. I have tried to un plug the tv and also left it pluged in and no change, the light keeps blinking and the tv will not turn on. I only pray there is an easy fix to this or im out a tv. Can you help me? Thank you, Joann

    Reply

    Re: JVC service or questions

     Terri Posted Jan 23, 2007

    Hello, I am hoping that you can help me figure out what is wrong with this TV. It is a JVC AV-36890. The first symptom was that the TV would shut itself off for no apparent reason. Now the TV will not power up at all. I have replaced the 1000uf35w because by reading the other problems with JVC tv's I thought that it might have been bad. I'm not completely positive that it is installed properly, but I'm pretty sure. I also installed a 1000uf 50w not the 35w. If there is anything else that you think I can try I would sincerely appreciate it! Terri

    Comment 1, Last comment by keith Dec 18, 2009

    Re: JVC service or questions

     Dariel Posted Dec 17, 2009

    Hi, I TURN MY STEREO ON AND A MESSAGE APPEARS ON THE SCREEN THAT SAYS "PROTECT" AND IT POWERS DOWN. JVC MODEL NO. CA-HXD7, CAN YOU HELP ME WHIT THIS PROBLEM THANK YOU.

    Reply

Pages:   « 1 2 3 28 29 30 31 32 33 34 643 644 645 »



  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed