PECHORIN'S home account archive eshop globalmediapro |
|
Home | Previous messagePlease look in http://www.network54.com/Forum/27766/message/1134164002/DCR-TRV725E+C-31-42+error+-+the+solution- I'm copying what I've wrote there: I had the same C:31:42 error on my DCR-TRV725E. Suddenly, out of nowhere, it started. On every cassette, sometimes with few seconds disturbed playback or few seconds of rewind/forward. I searched the Internet and found this forum. People here said that the solution was to take the camera apart and put it back together - well, it WORKED !!! I took out all the screws I could see (except the ones near the LCD). Note the two different screws near the button panel opposite the LCD screen. I pulled out the front of the camera, and then separated it into two parts in the middle all the way from the lens to the battery. In the cassette compartment "area" I only took out the plastic cover (didn't touch the screws of the mechanism inside). Be careful on the cables connecting all those parts. The camera was disconnected into 4 parts (lens, left with LCD, right with cassette compartment and battery, the 4th is this small i.Link cover on top aside). The ONLY thing I touched was this small transparent purple stick near the middle of the cassette compartment - just near the drum. I cleaned it a bit with ear cleaner. I don't know if this did the trick, but that was the only thing I can think of. Then, when the camera was all wide open, I connected the battery, inserted a cassette - and it worked. I felt like in terminator 2 when the robot comes back alive. I saw that the tape is rolling and not stopping and beeping, I could not look through the eyepiece since I had to hold all the parts in my hand, so my girlfriend looked. I put all the pieces together and it still worked. I could record and playback. All this disassembling and assembling happened 2 hours ago. God bless the Internet :)
2 comments
hi. I had the same problem on my trv 340e C:31:42. I tried many things. I thought it is the condensation but after some time found out that it is the assembly. first, i tried to remove battery and isert back. then load the tape. it works. Then after some time, it just refused to do so. second. I tried to open the casing etc and fixed back. put the whole thing in a air tight container with fresh silica gell. fixed back and it's ok. third. after some time, nothing seems to work. I sent it to Sony and they changed the assembly chasis. I misplaced the resit so i cannot recall the exact part no. It has worked since. It comes with a 3 month warranty. They also replace a cable and one small part. All in comes to about RM400 which is around USD120. I was thinking to buy a new panasonic 3ccd which is very very much cheaper than the sony 3ccd. Also I heard that it is quite durable. One word of advice. When loading or removing the tape, please make sure you tae great care and caution. Do it gently and avoid putting unnecessary pressure on the casing that receives the tape. Else, your assembly will misaligned or something and it will just lead to this similar error. Thank you so much! My camera was doing the same thing, so with fear and trembling, I took it apart and put it back together. IT WORKED! Does anyone know why??? |
|