I am in the same postion that you are in. I also have 2 Bloomberg monders with no power supply, and when I read that you had the same problem and have not found an anser yet, I deceded to take an ohm meeter to them an dope out what I could figer out, And Gess What. I am using one of those moders to type out this messeg. Hears the Deal. That 5 pin Din (same as a MIDI conecter) is the whay it gets Powered. If you Count the pins that come off the cable to the moniders from Left to Right (Left being pin 1, Right being pin 5 and lower midal pin being 3). You can take an old computer power supply or a Disk drive power supply and Din coneter and a soldering Iren and get these moniders up in less the 30mins. So hears how you Wire it: pin 1) +12 volts to Monider B pin 2) +12 volts to Monider A pin 3) Ground pin 4) Ground pin 5) Ground Note there is no 5volt line So it makes is so simple. Also Note: if your not shore whitch pins are witch. Take an ohm meater out and make shore there are no shorts between pins. it there are, then thay would be pits 3 and 2. I hope you have as mutshluck,

Reply