PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home | Previous message

Re: JVC GR- no sound when hooked to TV

Bob Posted Dec 01, 2004, in response to:Rick

Rick, Look at the cable that goes from the camera to the TV. If it is like most DV cameras, it will have a mini, single pin connector that plugs into the camera. The other end plugs into your TV and should have 3 RCA plugs; Yellow (video) and Red & White (left & right channels of the audio). If you only have 2 wires to hook up to the TV, that is your problem. That kind of cable is for mono audio. You need to get a stereo AV cable. If your connections are different than what I described, the concept is the same; you should still have 3 wires going to the TV. Other than that, I would make sure you can hear audio on the camera when you play it back. That will verify the tape is OK and everything internally is working except for possibly the external audio output circuit, which would take a good repair tech to figure out. Hope this helps.

Reply

Share |
0 comments



  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed