I have the same problem. I have JVC GR - FX 11 and getting Condensation please wait and this goes on and on and on. If someone has solved this problem, or have any other info i will be happy. And i need manual for that camera to. Thanks in forward.

Without wishing to cause offence but I think you are adopting a somewhat simplistic attitude towards this task, however it should be pointed out that as repeatedly stated in numerous postings any info has to be sent to a "DIRECT" e-mail address for technical reasons, you having chosen to restrict yours! Please also note!! - AN IMPORTANT POINT CONCERNING THE MODIFICATION. The instructions given are really aimed at technically minded people of a "practical" nature who are acquaint at working on smaller electro-mechanical devices of a precision nature or who have a flair for this sort of thing, and so in the interests of not making the situation any worse I would strongly advise anyone who does not really come into that category NOT to attempt this work, as it involves separating the case and the unscrewing the main circuit board to gain access to the board below it, this requiring the disconnection of ribbon cables etc, it is also necessary to carry out the precision soldering of two "very" narrowly spaced PCB pins, so the possession of a fine tipped soldering iron is also absolutely essential! So taking the above into consideration the qualification mentioned is really a MUST!! It should be emphasised that there are "NO" shortcuts into permanently getting over this problem other than what's been aforementioned, as if the "no dismantling" dew sensor cleaning procedure doesnt help but the "partial dismantling" memory reset "does", this can only really be adopted as a stop gap measure as the CPU could lock up again at some point in time, and unfortunately in many cases does!!

Thanks! and the "first stage" to try of the dew sensor cleaning info has now been sent via DIRECT e-mail.

i was unaware that selecting the option not to show email addy would stop the response. Does your comment imply that this is not a lasting resolution to the problem. Is the software hardware of this model doomed to fail again? If so is this a design fault?