"I replaced the STK392-110 with STK392-150 and it worked. Basically here's how I did it. First, I removed the board which the STK chips are attached to. The board which the STK chips are attached to are at the very inside of the TV. You will see two black heat sinks where the ships are located. There are 3 tabs/clips to push and to be able to remove the board. Mark the cable that you will remove out of the board so you know how to put them back. I just scribe color code to the plastics. To remove the solder, use a wick and a 45watt soldering iron. Place the wick on top of the solder and heat it up with the soldering iron. The solder will be absorbed by the wick. It's a clean process. Install the NEW chip on the board. Screw the chip then solder the terminals. T The process took 15mins." this guy is so full of crap i have been trying to unhook one of the wire connecrior and it is taking well over 15 mins. Also what would be the best way to solder the new chip in with out haveing the solder run together?

Reply