The condensation error relates to the dew sensor or dew-sensor circuit. The dew sensor comes on the motor bracket assembly. I have some in stock for $24.95 and also an instructional .pdf if needed.

Dew sensor cleaning procedure sent via DIRECT e-mail, this being classed as an "initial" stage of rectification as in many cases disabling of the sensor is the only guaranteed permanent cure. -------------------------------------------------------------------------------- PS:- AN IMPORTANT POINT CONCERNING ATTEMPTING THE MODIFICATION. The instructions supplied are really aimed at technically minded people of a "practical" nature who are acquaint at working on smaller electro-mechanical devices of a precision nature, or who have a flair for this sort of thing, and so in the interests of not making the situation any worse I would strongly advise anyone who does not really come into that category NOT to attempt this work, as it involves separating the case and the unscrewing the main circuit board to gain access to the board below it, this requiring the disconnection of ribbon cables etc, it is also necessary to carry out the precision soldering of two "very" narrowly spaced PCB pins, so the possession of a fine tipped soldering iron is also absolutely essential! So taking the above into consideration the qualification mentioned is really a MUST!! It should be emphasised that there are NO shortcuts into getting over this problem other than what's been aforementioned, and even if the memory reset does affect a cure it can only be adopted as a stop gap measure as the CPU could lock up again at some point in time, and unfortunately in many instances does!!