My daughters/son in law's receiver came up with the infamous 'overload' message after many years of operation without any troubles... btw - they also loved it! Checked fuses ..all ok, have no manual and was about to give up fixing this receiver without a schematic, when I went online and saw all the problems blogs. I proceeded to visualy inspect all the fuses (they all had checked ok with a meter), but all looked good. To follow up the reported F70 messages, I didn't find a 1.25A, but the closest thing .. a 2A on the board attached to the power x-former. When I removed this fuse and powered it up, the F70 fuse message came up. Replaced the fuse (with power removed) and the F70 error signal was gone ... but also the 'overload' error signal! It appears that removing the F70 fuse and powering it on, then replacing it had cleared the 'overload' error message also! Hope that helps some of you.

Reply