PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home | First message in thread | Previous message

Re[2]: Powered Subwoofer

Ketil Posted Apr 26, 2007, in response to:Timo

Hello! I have the same problem with my Sub. The circuit-board is burned and the heatsink become very warm and there is light hum in the woofer -speaker. R3 is burned. Yesterday, the sound at idle(no music at the input) suddenly start to 'wobling'(sounds like; flop-flop-flop) and I had to disconnect the unit. I'd like to repair it an wonder if you have found any electrical schematic that can halp me(us)? By the way; the two capasitors C20 og C21 connected from the two rectifier input terminals to ground, which you have discussed, are not defective on my circuit-board and they have the marking: 471 1KV (470pF and 1000volt). Best regards Ketil Walaker Norway meskem@online.no

Reply

Share |
0 comments



  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed