ok the dew error sensor on the pv-l600d is located on the flex cable that control the on and off one's you remove the rigth side cover you will have to remove the power switch to see it since the sensor is on the cable there is no way you can jump it or add a resistor, all you can do is follow the flex cable and add a resistor of 3.4k ohms at the connector FP3 PIN 3 AND PIN 13 that will fix the dew error the connector is located under the chasis on the control board you will have unsolder two legs from the chasis to get to it. remember that you will need a soldering iron with sharp tip and a magni-glass good luck.

Reply