PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home | First message in thread | Previous message

Re[4]: Convergence problems on AV-48WP30

Trevor Posted Oct 11, 2006, in response to:Eric

Eric, I see you have some solid advice. I checked on the internet about the convergance problem with my JVC AV48WP30, ordered two new chips STK-392150 to replace the 110 and it still has the same problem. The red is off, I tried to allign with the remote after pressing the white button on the convergance board but the resd does not move side to side, can you help. Trevor

Reply

Share |
1 comment

    There are six 1 watt resistors in the convergence yoke return circuits. Check them. In your case where the red will not adjust side by side (top to bottom) pay particular attention to R842 (2.2 ohm 1 watt). Eric

    Comment 1, Last comment by Trevor Oct 12, 2006


More

  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed