PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home | Previous message

Re: NEC TV Model FS6391

Eric Posted Dec 15, 2005, in response to:Frank

VCR outputs are selectable either Channel 3 or Channel 4. Be sure that the Antenna/Cable Input to the VCR is good or else put the VCR in Play Mode with a known good cassette inside. The VCR output should switch from Tuner to VCR and you should see the picture on either channel 3 or 4 whichever the VCR is set to. If not check the cable between the VCR's RF Out and the TV Antenna In. Eric

Reply

Share |
1 comment

    Re[2]: NEC TV Model FS6391

     Frank Posted Dec 17, 2005

    Thanks Eric for that info. I still can't make the vcr affect the TV picture. The picture on the TV is going from the aerial through the vcr then to the TV so I assume the cables are ok.

    Comment 1, Last comment by nick May 04, 2006


More

  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed