PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home | First message in thread | Previous message

Sony Blinking LED on Front Panel

Eric Posted Nov 10, 2005, in response to:brad

The Standby Indicator on the front will flash to indicate an error has been detected. The error code will be a series of flashes that repeat after 3 seconds. Of course "0" flashes indicates a totally dead set (possible power supply problems). But "4" flashes indicate a loss of vertical sweep and "5" flashes indicate a no raster condition. The No Raster condition can sometimes be overcome by slightly increasing the Screen Control. These sets also have a Self Diagnostic function that shows a list of past failures, but in order to view it the set must have a picture. That doesn't make much sense. Eric

Reply

Share |
0 comments



  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed