error message - warning condensation operations paused

i had a chook at the msgs here about the condensation error msgs on the grd30/70/90 series and after having this problem this morning and blowing it out with a hair dryer i thought i'd pull the damn thing apart to do a hard reset like is suggested by nearly everyone thats had this problem......i had a good look at the silver post with the sensor on it behind the head and was going to clean it first before i pulled it apart.......now on the plasic tape carriage cover right beside the operations switch on side is a little clip on cover that you can take out to adjust your tape height but it also exposes the condensation sensor .........before cleaning and pulling it apart i took the clip off cover off and EXPOSED THE SENSOR TO A BRIGHT LIGHT........I THINK THAT MIGHT RESET IT AS I HOOKED THE POWER BACK UP AND THE ERROR MESSAGE IS GONE AND THE CAMERA IS BACK TO NORMAL !!!!!!!!!!!!!! thought you all would like to know it could be that easy.....will let you's know if the problem re-occurs

Reply