PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home

ps2 eject/reset ribbon reconnect

lj Posted Apr 23, 2005

Please help me reconnect the ribbon to the console.

I disconnected the eject/reset ribbon to my ps2 and I don,t know where it goes in the mother board.

Reply

Share |
3 comments

    If it's a version 4-8 PS2 send me an e-mail and I'll upload a photo showing the cable installation procedure. Eric

    Comments 6, Last comment by George Linnane Jun 03, 2009

    Hey I was trying to mod my ps2 it is a (SPCH? or SPHC?) 30001 and the directions said to disconnect the cable, but it wasn't specific enough to which cable to take apart, so i tugged on the cable that was stuck into my ps2, and everything was fine i didn't know if i broke it or not until i screwed in the mods; then I tried pressing the start/eject buttons and they didn't light on or start, even with the back power switch on to (|)

    Reply

    hi i cam across this and im having the same problem with the reset and eject button cause my ribbon came off and i dont know how to reconnect can someone help please my email is auntmina@sbcglobal.net

    Reply




  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed